22.3 x 22.3 x 20.5 cm
Some products that we think would go well with the Ultimaker 2+ (Plus)
Hover on the numbers to see the features
The heated bed will ensure that your prints are firmly stuck to the bed when printing and easily removable when the bed has cooled. The bottom of your prints will also be very flat and shiny.
Built In Display & Control Wheel
You can see the status of your print and modify the settings mid print.
Print straight from an SD card so theres no need to connect the printer to your computer if you don’t want to.
Easily switch between 0.25, 0.4, 0.6 and 0.8 mm nozzles for greater detail or faster print speed.
Low Cost, Open Material
You can use pretty much any 2.85/2.9mm filament from any manufacturer which keeps the cost of materials down to a minimum.
Optimised Airflow, smoother prints
The new fancaps ensure the airflow is aimed perfectly below the nozzle and equally from both sides.
Geared Feeder, Increased Reliability
The innovative feeder allows you to easily swap filament and choose the correct pressure for your filament.
Quicker Heat Up Time
The new powerful 35W heater means that the heat up time of the Ultimaker 2+ has now been halved to approx 1 minute.
Whats included in the box?
- Fully assembled & tested Ultimaker 2+ 3D printer
- Cura (which is downloaded here)
- Power supply, cable and UK plug
- One roll of Ultimaker filament (0.75kg)
- USB Cable
- Swappable 0.25, 0.4, 0.6 and 0.8mm nozzles
- Ultimaker Phone App
- Calibration card to level the build plate
- SD Card
- Glue Stick
- Hex Wrenches